What is the function of the cable arranging device?

This article is about the introduction of the cable arranging device, the concept of a cable arranging device, the precautions for installing the cable arranging device, and the function of the three lining device.

When dismantling equipment or dismantling other equipment, we often find that many equipments have a coil, and the coils are very good, the rows are very neat, but when we unfold the line wrapped inside, we want to re-entangle it, this When you find out how to wrap and not wrap back to the original state, why is this? The original lines are wrapped around the machine, Imagine so many lines, if you rely on artificial, you can’t say anything, even if you wrap Well, it also consumes a lot of manpower, material resources and time. This is not allowed in the era of efficiency. The appearance of the cable arranger solves this problem, and the speed is fast and efficient. So, what is a cable aligner? What are the functions of the cable arranger? Let's introduce Xiaobian to the following.

Cable arranging concept

What is a cable arranging device? Since the cable arranging device is less used in our daily life, it is generally used in industrial applications. So everyone is relatively new to the cable. What is a cable arranging device? In fact, the cable arranging device is a kind of mechanical device that can make the messy cable, the steel wire rope and other wires tidy. The technical staff only needs to transfer the button of the mechanical device to set the pitch of the cable. , to achieve uniform cable, and no swimming clearance, to facilitate the efficiency of the manufacturer in the mechanical operation of the project.

Precautions for installing the cable arranging device

The cable arranging machine plays an important role in the production of large-scale manufacturers. Therefore, special attention should be paid to the installation of the cable arranging device to avoid damage. Let me talk about the installation instructions of the cable arranger:

1. The installation of the cable arranging device generally needs to be installed according to the process requirements of the model and size of the production machinery and equipment, and then the accessories such as rails, polished rods and bumpers are installed.

2. For the surface hardness of the polished rod of the installation of the wire arranging device is generally HRC50 ° ~ 60 °, its outer diameter tolerance requirements: h6, straightness requirements: <0.1mm / m, length requirements: generally should not choose greater than the diameter of the polished rod 20 ~30 times, both ends of the polished rod must be chamfered 2 × 30 °.

Cable arranging function

The cable arranging device can maintain the angle symmetry between the movable arm and the fixed arm, and can be replaced at any time when the pressure of the compression spring is insufficient.

The wire arranging device can be used to adjust the speed of operation, can meet the wire thrust, and can extend the service life of the machine. What needs to be reminded here is that it is appropriate to adjust the thrust of the cable arranging device. Otherwise, the wire aligner may not be reversed.