ã€Pump News Asia】 gear pump is to rely on the work of the pump cylinder and the meshing gear formed between the volume change and movement to transport liquid or make it booster pump. Because of its simple structure, low price, reliable and other characteristics, has been widely used in daily production and life, but because of the wide range of gear pumps on the market today, so for the gear pump models are not uniform, So as for the gear pump models in the end what are the rules, Xiaobian following to collect specifications on gear pump models, I hope your purchase help. Analyze the gear pump model Look at the following group of international gear pump model description: CBN - E300 - RF â–¡â–¡ CB said gear pump name. N represents the gear pump design code. Design code also includes KSN E that the pressure level. Gear pump pressure levels are divided into: D 10MPA; E 16MPA; F 20MPA; G 25MPA. 3 said the gear pump module, the modulus is divided into 1, 2, 3, 4, 5. 00 that the nominal displacement, usually 0.6ml / r-63ml / r. R represents the flange installation form. O is a diamond, R is a distance, S is a square. F said the port form. F is the flange, T is special, and L is the thread. â–¡ indicates the shaft extension. B represents a flat mouth, H represents a spline, Y represents a cone, P represents a single bond. â–¡ indicates the direction of rotation. L is left-handed, R is right-handed, and T is bidirectional. Then a case of 2CG series of high temperature gear pump model description: KCG â–¡â–¡ PA K said safety valve, CG said gear pump, â–¡ said flow, the unit is m3 / h, â–¡ mpa said the pressure is the number of mpa. TGB2CG21.6 T represents a copper wheel, G represents a high temperature, B represents a stainless steel, 2C represents a double gear, G represents a high temperature oil pump, 2 represents a flow rate of 2 m3 / h, and 1.6 represents a predetermined pressure of 1.6 MPa. Some gear pump to see the same model, but its performance parameters may not be exactly the same, for example: 2CG3 / 0.6 expressed as: inhalation and discharge caliber (unit: mm): G1, flow 50L / min; 3m3 / h, discharge pressure 0.6mpa, inhalation height of 3m, volumetric efficiency of 52n%, this type of high temperature gear pump should be equipped with power 2.2KW, model Y100L1-4, speed 1420r / min of the three-phase asynchronous motor. Another manufacturer 2CG3 / 0.6 high temperature gear pump is expressed as: flow 55l / min, 3m3 / h, the discharge pressure of 0.6mpa, vacuum suction test for the 5m, the working temperature of 250 degrees Celsius, this type of high temperature gear pump should be equipped with power 2.2KW, model Y1001L-4 motor. These are some of the basic description of the international gear pump models, as each manufacturer will be based on the product some of the specific description of the characteristics of the model elaboration, it also reminds consumers to buy certain product models must view some of the basic information . . This article is copyrighted industry interconnect (Xiamen) Co., Ltd. All are welcome to reprint, please indicate the source and author of: Asian pumps Network Editor: Zeng Fenfen (QQ / micro letter: 2355962927) starting: http: //beng.liuti.cn / (Service Hotline: 400-6030-811)