The main application of high temperature heat transfer oil pump Petroleum and chemical industry; Oil industry; Synthetic fiber industry; Textile printing and dyeing industry; Plastic and rubber industry; Paper industry; Wood industry; Construction industry and machinery industry; Food industry; Pharmaceutical production; Hot oil heating circulation system Is widely used. When using high-temperature heat transfer oil pump should pay attention to the following aspects: â… , turn on the power, turn on the relevant instrument switch; When the pump reaches normal speed, and the instrument shows considerable pressure, gradually open the output valve on the pipeline and adjust to Need condition. In the case of output valve closed gate, the pump can not work continuously for more than 3 minutes; â…¡, just started running, the production process equipment slowly heated to 100-130 degrees, external lubrication gear pump, high temperature heat transfer oil pump and Maintain the temperature at the continuing operation, dehydration degassing to heat the oil in the water completely evaporated, the equipment was heated to operating temperature; â…¢, the boot process, always pay attention to the motor power readings and vibration conditions, the vibration value does not exceed 0.6mm, if there is abnormalities should stop inspection; â…£, in the first 3-4 hours of operation, the equipment is heated to operating temperature, turn off the pump, check the pump shaft and motor shaft coupling coaxiality, pump shaft and Motor shaft deviation should be controlled within the allowable range, hand shaft rotation should be light and flexible and vibration-free rotation, if the hot oil pump does not meet the above requirements, high temperature gear pump should be re-adjusted; â…¤, by impeller-side ball bearing installation When the high-temperature heat-conducting oil pump has a dust cover on the side toward the impeller installation, before driving into the thermal oil lubrication; by the coupling side of the ball bearings, with complex calcium-based high temperature grease When reinstalling the bearing, heat pumps have the same side of the dust cover side toward the impeller to be installed, the installation grease filling. â…¥. After each ball bearing has been operated for 3000 hours, it must be dismounted and cleaned with diesel oil to check for damage. If it is damaged, it must be replaced with a new one. The heat pump is suitable for conveying high temperature liquids without solid particles. To ensure the full performance of the pump and have a good useful life, our company remind customers to use the correct operation of the above matters to extend the service life of high-temperature heat-conducting oil pump.