[China Aluminum Industry Network] Changing the sliding door, usually refers to adding a circle between the outer frame and the door core, due to this layer of the line, making the normal sliding doors become more beautiful, more with solid wood doors Wind meter. So is this kind of sliding door price high? That's right, changing the sliding door is a middle-to-high end product in the sliding door, so the price will be higher. However, the cost of its data is not very high. The reason is that even though there are more laps of conversion bars, the cost of aluminum materials has increased, and the cost of door cores has been reduced, because the door glass of this type of door is usually used. The glass is usually bright without using technical glass. In this case, the cost of it will not be high. Thus, such doors are currently favored by merchants and consumers in the market.
How to make a sliding door with a conversion bar of course. Although the cost is not high, but the processing is still relatively labor-intensive, because the conversion bar is connected at a 45-degree angle, and most of the conversion bar shape is irregular, there are still some difficulties in using the cutting machine to cut the point, the following Introduce some experiences for our reference and hope to help us.
The major difficulty in making such a door is to change the bar. Due to the irregular shape of the bar, it is difficult to ensure that the bar is accurate and symmetrical.
First and foremost, let us calculate the scale of the upper-middle-lower cross, then the transitive transition of the upper-middle-down cross is roughly the same size as the cross. Once we cross it, we assume that the cross-section is 800mm long. Then we take the transformation bar to a rough scale, which is longer than the horizontal frame. It is assumed to be 900mm, not too short, too short and simple to saw. Then, as shown in the figure below, place the two conversion bars on the horizontal frame, preferably with screws, then place them on the saw at 45 degrees, like cutting vegetables, and cut them a little, know that the cut and horizontal boxes are all on the line. This ensures both the accuracy of the scale and the symmetry of the bevel at the transition.
Then, the cut transition bar and the horizontal frame are all connected. The transition bar on the mullion box is also cut so that it is a good measure. First cut a horizontal frame of this scale, and then cut the bar according to the horizontal frame.
After that, it is assembled, and usually this type of door is assembled, from one corner to the other!