1. Check the sealing quality. According to different materials, diameters of containers and production efficiency, properly modify the "SETTING BUTTON" button to make the sealing quality the best.
2. Insert the plug on the hand-held sensor head into the socket on the panel and tighten it. Note the positioning gap.
3. Plug one end of the power cord into the socket on the rear panel of the chassis and the other end into the power supply socket. Be sure to use the single-phase three-wire power supply.
4. Open the power switch (POWER SW.) on the rear panel of the chassis and press the SWITCHING button. The WARM UP green indicator is on and the machine can work.
5. Place the sensor head on the lid of the container and press the start button on the handle. At this time, the red HEATING indicator is on, indicating that it is heating, the sensor head should not be removed, and the red HEATING indicator light should be turned off. Go to the sensor head, wait for preparation (WARM UP). The green indicator light is on or the buzzer sounds in the machine. The next container can be closed.
6. Hold down the "SETTING BUTTON" button and set it to a suitable value, typically between 0.5-2.0 seconds.
7, choose to level the table, stabilize the machine, you can open the chassis feet so that the machine panel is easy to observe.
2. Insert the plug on the hand-held sensor head into the socket on the panel and tighten it. Note the positioning gap.
3. Plug one end of the power cord into the socket on the rear panel of the chassis and the other end into the power supply socket. Be sure to use the single-phase three-wire power supply.
4. Open the power switch (POWER SW.) on the rear panel of the chassis and press the SWITCHING button. The WARM UP green indicator is on and the machine can work.
5. Place the sensor head on the lid of the container and press the start button on the handle. At this time, the red HEATING indicator is on, indicating that it is heating, the sensor head should not be removed, and the red HEATING indicator light should be turned off. Go to the sensor head, wait for preparation (WARM UP). The green indicator light is on or the buzzer sounds in the machine. The next container can be closed.
6. Hold down the "SETTING BUTTON" button and set it to a suitable value, typically between 0.5-2.0 seconds.
7, choose to level the table, stabilize the machine, you can open the chassis feet so that the machine panel is easy to observe.
Building Tempered Glass,Door Glass,Window Glass,Silkscreen Glass
SHANDONG TOP LEADER GLASS CO.,LTD , https://www.topleaderglass.com