Industrial explosion-proof air-conditioning piping pipe bundle connection operation requires explosion-proof air conditioners to mount the indoor body. Pass the pipe through the hole in the wall, and then hang the explosion-proof indoor body on the two hooks on the upper part of the wall plate. Lift up the indoor body when installing, make it close to the mounting plate, move up and down, so that the bottom of the indoor body is hung on the bottom hook of the wall plate, move back and forth, 'move it back and forth to check if it is firm; grab both hands. The body presses the body against the wall plate until it hears a "click" sound.
1. The connecting section of the pipe fitting and the pipe should be wrapped with a special insulated sleeve. The two pieces should not be exposed or exposed to the air so as to avoid condensation and leakage.
2, the drain should be straight, can not be bent.
3. In the installation position, the connecting wire should be on the top and the pipe should be laid flat. The drain pipe should be below.
4, banding should be partially overlapped. (The overlapping part should be 1/2 of the width of the wrapping tape.) From the inside to the outside, the wrapping is required, and uniform dressing is required, and the elasticity is moderate.
5. After the drainage pipe is wrapped to a certain length, the exit should be set aside.
6, when wrapped to the end of the pipe about 50cm, the connecting wire should also be thrown out no longer bandage, to facilitate wiring. The end of the pipe should be set at about 15cm without bandaging to facilitate the connection between the connecting pipe and the high and low pressure valve body of the outdoor unit.
1. The connecting section of the pipe fitting and the pipe should be wrapped with a special insulated sleeve. The two pieces should not be exposed or exposed to the air so as to avoid condensation and leakage.
2, the drain should be straight, can not be bent.
3. In the installation position, the connecting wire should be on the top and the pipe should be laid flat. The drain pipe should be below.
4, banding should be partially overlapped. (The overlapping part should be 1/2 of the width of the wrapping tape.) From the inside to the outside, the wrapping is required, and uniform dressing is required, and the elasticity is moderate.
5. After the drainage pipe is wrapped to a certain length, the exit should be set aside.
6, when wrapped to the end of the pipe about 50cm, the connecting wire should also be thrown out no longer bandage, to facilitate wiring. The end of the pipe should be set at about 15cm without bandaging to facilitate the connection between the connecting pipe and the high and low pressure valve body of the outdoor unit.
Wheel Bearing For Nissan,Front Bearing,Rear Hub Bearing,Front Hub Bearing
SHAOXING ZHENGHONG AUTO PARTS CO.LTD , https://www.kontinental-bearing.com