What kind of harm will the fire emergency lighting failure bring?

Case 1: 7 December 2010, Fuzhou Ting Street B, high-rise apartment on the 8th floor warehouse fire, dozens of residents in the building to escape the 4th floor, 4th floor found the following fire emergency lights are not bright, crowded, Stampede and wounded accidents occur immediately.

Case 2: In May 2012, a fire brigade unit in the inspection found that some fire emergency lighting time is less than 5 minutes.

Incident accident analysis

1 ) Failure to perform regular discharge and charge operations in accordance with the specified time will result in deterioration of the battery;

2 ) The system regulations are not perfect, and the regular charging and discharging operation requirements are not included in the operating system;

3 ) The supervision of the territorial supervisor is not in place, and there is no supervisory staff to implement the operating procedures;

4 ) Defective training and lack of relevant knowledge on the use and maintenance of emergency lights.

Advice on safety management of accidents

1 ) Conduct a weekly inspection tour to observe the normal operation status of the fire emergency lights;

2 ) Perform one test operation on fire emergency lights every month to find problems in a timely manner;

3) As a rule, every six months by one discharge, the charging operation to prevent failure of the battery aging, and save the recording operation, to increase the operating method of visually labeling;

4 ) Improve the system rules and clarify the responsibility for the charge and discharge operations of post personnel;

5 ) Strengthen territorial supervision and incorporate the use of emergency lighting maintenance into the job training plan.

Emergency lighting related knowledge

Operation method

1. Daily inspection: press "test switch" once a month, and the emergency light is on, indicating that it is normal, otherwise it will be repaired.

2. Regularly discharge and charge:

1 ) Press "ON" every 6 months, and the emergency light will be on to discharge. Duration to 60-90 minutes , indicating that it is good, otherwise repair.

2 ) After the discharge is completed, press “OFF” to turn off the emergency light and charge it automatically.

Products Recommended:

GRS688 Hand Emergency Multifunction Light

GRS688 manual emergency multi-function lamp uses high-power three-phase alternator manual power generation principle to generate electricity, the built-in rechargeable 3.7v/500mah polymer lithium battery is charged by the switching power supply circuit , can be used for energy storage emergency lighting, when the flashlight is used ; It is also possible to charge mobile phones/digital products. Both manual charging and solar charging can be used, as well as charging with an ordinary power adapter.

Features:

1) Environmental protection: Do not use dry batteries, reject environmental pollution, use AC three-phase generators, and resist battery interference.

2) Energy saving: hand cranking and solar charging, without using grid energy;

3) Multi-function lighting: It can be used as spotlight or desk lamp, but also as warning light;

4) Radio: You can listen to favorite channels at any time;

5) LCD screen clock display: date & time display;

6) Emergency power supply: DC standard output and input interface are available for emergency charging of mobile phones, MP3s, cameras, etc. It also accepts power adapter charging and energy storage;

7) Alarm: The red light flashes while the alarm sounds;

8) Safety: Self-generating low voltage power supply system;

9) portable: small size, light weight, easy to operate;

10) Applicable: Suitable for vehicles, travel, camping, mining, disaster relief and other passive applications

Specific product parameters, see: http://

This article is edited and compiled by China Rescue Equipment Network. Please indicate the link.