During the installation of our home shower room , if we have enough knowledge of the installation steps and precautions for the shower room, then we ourselves are a very good supervisor. Today, with the small series to see the installation of the shower room and precautions for your reference.
Shower room installation steps
1. To install the shower tray, the first is to combine the bottom basin parts to determine the level of the bottom basin, to ensure that there is no water in the basin, the pipe to expand and contract with the distance, and then the net pelvic floor and floor drain Strong connection.
2. Testing and protection: After the installation, it is necessary to test the water to ensure that the water is unobstructed. Finding and punching holes: Use a pencil and a level rule to determine the drilling position of the aluminum material against the wall, and use the impact drill to drill holes.
3. Install the aluminum material: Knock in the rubber particles at the drill hole and lock the aluminum bar to the wall with screws.
4, fixed glass: The glass clamped locked in the hole in the bottom basin, and then fixed with screws.
5. Install the top pipe: Find the corresponding location above the fixed glass drill hole, install (straight/oblique) holder and connect the top pipe. Fix it to the top of the glass with a bender sleeve.
6, security device rack: measuring position installed sanitary ware
7. Install the door: Install the hardware of the door and install the hinge at the reserved hole of the fixed door. After loading, adjust the position of the axis of the lotus leaf until the door feels best.
8, do a good job of waterproofing: In accordance with the requirements of the glass on the side or below the installation of suction or water strips. Seam the aluminum with the wall, the glass and the bottom pot joint seam tightly with silicone.
9. Debugging and tightening: Check whether each part is comfortable and smooth, and find that the problem should be adjusted in time. After adjusting, tighten the corresponding screws to make the shower room more secure.
10. Closing work: The decorative aluminum strip will be stuck in the wall aluminum to ensure its neat appearance. Finally wipe the entire bathroom with a rag.
Overall shower room installation precautions
1. In order to ensure the smoothness of the whole shower room pulley, lubricant or peanut oil can be added properly.
2. When the pulleys of the track-type shower room are in a loose or detached state, it is necessary to find maintenance personnel in time to adjust and ensure the effective bearing of the movable door on the pulleys, and then wipe the foreign materials inside the track with paper towels and peanut oil to ensure smooth sliding; avoid impact activities. Door, so as not to cause the active door to fall off.
3. Do not hit the glass with sharp hard objects, especially the four corners.
Information on the installation of the shower room was introduced here for everyone. I hope this article will be helpful to everyone. If you still have something you don't understand, you can leave a message to Xiaobian at the bottom. We will answer your questions as soon as possible.
shower room
Sushi Knife Set,Kitchen Knife Block Set,Japanese Steak Knives,Different Types Of Kitchen Knives
Garwin Enterprise Co.,Ltd , https://www.garwincn.com