To judge whether the tape is good or bad, simply judge: 1. Look at the total thickness of the tape. 2. Look at the tension of the tape. 3. Look at the glue (that is, sticky) of the tape. 4. Look at the peeling force of the tape. Another way is to take a piece of tape and seal it on the box to see if it is easy to lift, whether it is easy to break, whether the surface of the carton can be destroyed after tearing. The common sealing tape in daily life (BOPP biaxial stretching Propylene is an indispensable daily necessities for any precision steel pipe enterprise, company, and personal life. However, compared with the current situation in China, there are many manufacturers and the technology is uneven. Moreover, the technical content of the domestic tape industry is still at a very low stage, and the national fume hood does not have a clear choice for this. People often know the tape is in a very ignorant stage. They think that the price is low and the viscosity is good. In fact, these are wrong understandings and judgments. So how do you choose the quality of the tape? In fact, the glue of the tape has two standards in use. One is the initial adhesion and the other is the retention force. The two are inversely proportional. Under normal circumstances, the adhesive tape with a viscosity lower than 10 is less adhesive coating, generally only about 20 microns, such as stationery tape, tape for general promotion bundle. The initial adhesive force of a normal sealing tape is between 15 and 20, and the thickness of the tape glue is generally 22-28 microns. Is the thickness that meets the standard. However, most of the tapes on the market are mixed with chiller impurities, so the thickness is increased to cover the impurities. The glue is also mixed with toner, so the transparent tape will appear egg yellow and light green. This tape is generally inferior. of. How do you distinguish between colored tapes? For colored tape, it is generally more yellow and khaki. By pinching the adhesive and then pulling it open quickly, the rubber can be pulled off and the purity and transparency of the original film can be seen. You can also look at the thickness of the glue. If there is no glue pulled apart or pulled apart, there is a lot of impurities in the glue, and the glue has no cohesion. Second, there is too much water, and the snacks of Wuxi have been volatilized. At this time, the initial adhesion of the tape has been greatly reduced, and the feel can be distinguished. In fact, there are many ways to distinguish between good and bad tapes. As long as you pay more attention to your life, you can tell whether the tape is good or bad. Put on the water first, then scrape it off with a small blade.
solar street light is powered by crystal silicon solar cell,maintenance-free calve controlled sealed battery to store electricity,ultra-bright LED lamap as the light source,and controlled by intelligent charge and discharge controller,used to replace the tradional public electric lighting street light.
No need to lay cables,no need for ac power supply,no electricity charges; DC power supply,photosensitive control; solar street light has the advantages of good stability,long life,high lumious eeficiency,easy installation and maintenance,high safety performanc,energy conservation and environmental protection,economic and practical.
Solar Street Light,Solar Street Lamp,Smart Street Light,Solar Powered Street Lights
Jilin Province Wanhe light Co.,Ltd , https://www.wanhelight.com