Rolling shutter doors are made by splicing pieces of joints in parallel. Nowadays many of them are installed in large shopping malls or in front. Because they are not only convenient for contraction but also save space, they also have high safety factors. How can the roller shutter be installed? Here are three different types of roller shutter installation steps introduced to everyone.
1, electric shutter door installation method:
First, draw a line at the position of the door frame that needs to be installed to indicate the size. Note: The height in the frame is a little higher than the height of the door leaf.
Secondly, fix the door frame of the electric roller shutter door, but remember to reserve the groove on the ground on both sides of the hole.
Then, install the electric shutter door leaf. When installing, it is necessary to ensure that the electric roller shutter door is integrated with the wall body, and that the sealing property is good. Then, the hole and the wall body are painted to ensure the appearance. After painting, try to open and close the door.
2, fire shutter doors installation method:
a. According to the model of the door, measure the basic dimensions of each part of the product, check whether the opening of the door is consistent with the size of the rolling shutter, and whether the embedded position and quantity of the guide rail and bracket are correct. Then, measure the elevation of the hole and pop the two guide rails and the centerline of the reel.
b. Weld the backing plate on the embedded iron plate, fix the reel stand with screws, and install the reel. The installation of the drum should be flexible.
c. Install reducer, transmission system, skirting electric street system.
d, the pre-assembled curtain plate is installed on the drum. Followed by the installation of guide rails, in accordance with the provisions of the drawings, the two sides and above the guide rail welded to the wall embedded parts, and welded into the body, the guide rails should be in the same vertical plane.
e. Finally, install the water curtain spray system and connect it to the general control system. After installation, a trial run is performed, and the motor is opened and closed several times with the electric motor, and the state of no jam, blockage and abnormality can be adjusted.
3, automatic door crystal shutter door installation method
First of all, the motor is fixed on the main board, the chain is fixed on the wheel and the motor base gear connection, try to reverse the handle is upside down, if reversed, the remote control receiving box side has a black button to dial the other side to help.
Secondly, use the ruler to check whether the dimensions of the main board and the sub-board are correct. If the shaft is correctly placed on the side board, be careful to make a horizontal line; then use 10 bits to drill the hole 50 cm, and each must be straight; Then, use a 14-mother to weld on the shaft, remembering that it must be firmly welded; align the center of the first piece of the curtain with the hole in the shaft and fasten it with the fast wire.
Again, the blinds of the shutter doors are put through and sealed on both sides with a head. After sealing, use a rope to turn over the shaft to hold the curtain and use the rope to hold it. Then lift up the curtain and avoid being firm.
Finally, open the adult mouth at one end of the track and level the curtain door curtain.
Xiao Bian epilogue: The above is the introduction of three different types of rolling shutter installation method, I believe that through the understanding of Xiao Bian finishing content, we should know how to install the shutter door. If you still can't, you are advised to ask a professional master to install it.
Furniture Metal Bed,Metal Bed Modern ,Metal Bed With Cushion,Metal Bed
FOSHAN CITY LESHUN RONGHUI FURNITURE CO.LTD , https://www.sdwinfurniture.com