(1) Feeding workbench. The feeding workbench (Fig. 3) consists of a loading gantry, a feeding roller, a centering device and a feeding clamp. The loading gantry is placed on the plane below the inner side of the C-shaped open bed of the feeding member, and has a simple structure and light weight. The adjusting foot is installed under the loading gantry, and even if the bed is placed, the loading table can be easily leveled.
Figure 3 loading workbench
(2) The upper and lower materials are fed into the clamp. The machine loading table and the cutting work table each have a clamp feeding mechanism (Fig. 4), and the two structures are symmetrical. The feed is driven by the servo reduction motor. When the sheet is positioned by the movement centering, the feed clamp feed sheet reaches the specified position. The front end of the plate is positioned at the X2 shaft clamp port. After the position is sent, the movement is centered and extended. After the centering is completed, the opened X1 clamp clamps the sheet material and prepares to feed the punching hole; when the sheet material reaches the discharge side of the main machine, the feeding is started to start, and the clamp clamps the sheet material. The motor control starts to feed.
Previous page next page
Broken Colored Glass,Colored Glass Rocks,Terrazzo Flooring
G And S Enterprises Co., Ltd. , http://www.jsglassmarbles.com